The last step is to adjust the camera animation to properly frame up the shot. Ease and Whiz will not work when there are Rove Over Time keyframes on a property so you'll have to adjust that easing manually. If you need to further refine the easing you can right-click on any keyframe and select Keyframe Velocity to manually set the easing. The last step is to select the last Position keyframe for the circle layer and press f9 or use the Keyframe Assistant to set the same easing. There is no ease and whiz expression applied to Trim Paths 1/End, but there is easing so you should select that keyframe again, press f9 to set easy ease, or use the keyframe assistant to set easing for that keyframe. It should snap into position.īecause you used End instead of Start for Trim Paths you will need to select all of the Circle Position keyframes and use the Keyframe Assistant to Time Reverse the keyframes. Press the K key a few times until you get to the last keyframe for Path/Contents/Ellipse 1/Trim Paths 1/End and then drag the last Position keyframe for the Circle layer to the same frame. This will give you Rove Over Time keyframes for the Circle/Transform/Position property. When that is done, set a keyframe for the Circle/Transform/Position property at the first frame, the same frame that the first keyframe of Trim Paths 1/End is on, and then paste. The next step is to set a keyframe for Ellipse 1/Path 1 and copy or cut it to assure that you have copied the path to the clipboard. This will put the circle in the center of the comp. The Transform Ellopse Path 1/Transform property must be reset, You also need to reset the Anchor Point and Position property of the Circle layer. The second problem is with the Circle layer. Now when you copy the path in the path layer and paste it to a motion path it will line up. You need to reset Position and Anchor Point so that the Anchor Point is at 0, 0 (true for all shape layers), and the position is 960, 540. If you want a motion path to follow a path the transform properties of the layer with the path must all be reset. The most obvious problems are with the Circle layer and the Path layer. I checked your comp and it has a few basic problems. If you ease the in and out points for trim paths the easing will exactly match easing the position keyframes of the layer following the original path.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |